3M XT-1 - Remote Displays and Global Settings

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 61 of 65
Appendix: Timer Module
Report Groups
Perform the following procedure to change the Report Groups:
1. Enter the timer configuration menu, see above.
  • Select 6 Congure Timer > 4 Report Groups .
For reporting purposes, detector inputs can be grouped into Report Groups. Earlier
you learned how to name report groups. To setup report groups, you add detectors to
each named group. You can assign up to six detectors in a report group.
There are three type of report groups:
 • Independent(Startswithauniquedetectorinput).
 • Supergroup(Thesearecombinedreports,suchasLane1+Lane2=TotalLane).
 • Subgroup(Asthenameimplies,thisisareportofaportionofanindependentgroup).
To configure the drive-thru report groups, perform the following steps:
2. Configure all independent Report Groups, ensuring each independent group
starts with a unique detector input (i.e., If Report Group 1 starts with Order
Point 1, no other Report group can contain this detection point).
3. Configure any “Subgroups”, using the independent group as the parent group (i.e., “Service” can
be the Pay and Pickup Windows of a 3 point single lane drive-thru). Configure any Supergroups,
combining like groups into a combined report (i.e., Combine Lane 1 and Lane 2 into Total Lane).
Remote Displays
Perform the following procedure to change the Remote Displays:
 4. Enterthetimercongurationmenu,seeabove.
  • Select 6 Congure Timer > 5 Remote Displays .
There are 3 sections to the remote timer display:
 • Runningtimeforcurrentcustomer
 • Percentofallcustomertimesmeetingestablishedgoals
 • LEDDetectorIndicators
Running Time
For the running time, the user selects one of the following:
 • Anyofthe6DetectorInputs,or
 • Anyofthe6ReportGroups,or
 • Thegreetevent
This selection determines which data is shown. For example:
 • IfthePayWindowisselected,therunningtimestartscountingwhenthevehicle
arrives at the Pay Window and stops when the vehicle leaves the Pay Window.