3M XT-1 - Save Installation Settings; Technical Service Message; Reset Timer Database; Factory Setup (Restore Factory Defaults)

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 23 of 65
Configuration
Save Installation Settings
Note:
This function is only available to installers.
Perform the following procedure to save the current configuration into
permanent memory over the existing installation settings.
Important Note:
By performing this procedure you will be erasing the existing saved installation settings, making
it impossible to revert to the settings that were saved after installation.
 • Enterthecongurationmode,seepage5.
 • Select 14 Installer Setup .
 • Changethevaluefor Save Installation Settings to Yes .
Technical Service Message
Perform the following procedure to customize the Service Screen message.
 • Enterthecongurationmode,seepage5.
 • Select 14 Installer Setup .
 • Changethevaluefor Use Custom Tech Service Message? to Yes or No .
 • Ifyouchose Yes , enter the customer message.
Reset Timer Database
Perform the following procedure to Reset the Timer module database.
 • Enterthecongurationmode,seepage5.
 • Select 14 Installer Setup .
 • Changethevaluefor RESET Timer Database to Yes .
Note:
Resetting the Timer module Database will clear ALL vehicle timing data.
Factory Setup (Restore Factory Defaults)
Perform the following procedure to restore all of the configuration settings to the factory default settings. This
procedure should be performed only if the current configuration and the saved installation settings are unusable.
Important Note:
By performing this procedure you will reset the system to the initial configuration, making it impossible to
revert to the settings that were saved after installation.
 • Enterthecongurationmode,seepage5.
 • Select 15 Factory Setup .
 • Changethevalueof Restore All Factory Settings to Yes .