EasyManua.ls Logo

3M XT-1 - Greeter Message Properties; Change Playback Delay Time; Change Playback Mode; Set Greeter Playback through Headsets

3M XT-1
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 46 of 65
Appendix: Greeter Module
3. Using the
5
,
6
,
4
,
3
and Enter keys, select a message daypart. Use
the keypad to modify the Daypart Name, Start Time, and End Time.
4. Repeatforupto12dayparts.Thedayparttimescanbeoverlapping.
Greeter Message Properties
The Greeter Message Properties menu is a collection of settings affecting the message type GREETER.
5. Enter the greeter configuration menu.
6. Select
5 Greeter Message Properties
.
:GREETER MESSAGE PROPERTIES:
Playback After Delay Of
>
00
<
Seconds.
Playback Mode:<Alternating>
Playback To The Headsets?<Yes> i
Change Playback Delay Time
Playback delay time is the number of seconds between when the vehicle detector
detects a vehicle and when the greeter begins to playback the message.
Perform the following procedure to change the playback delay time:
7. Navigate to
Playback After Delay Of >XX< Seconds
where “xx” represents the current number of seconds.
8. Change the number of seconds to a new value. The range is 0 to 15 seconds.
Change Playback Mode
Perform the following procedure to change the greeter playback mode.
1. Navigate to
Playback Mode
.
2. Change the value of the playback setting. Your choices are:
•
ALTERNATING
–A different message plays for each vehicle that pulls up
to the customer order point. Multiple messages must be selected.
•
PLAY ONCE
–All messages selected play once for every
vehicle that pulls up to the customer order point.
Set Greeter Playback through Headsets
You have the choice of allowing the greeting to be played through the headsets
in addition to being played to the customer at the order point.
Perform the following procedure to enable or disable playback through headsets:
1. Navigate to
Playback To The Headsets?
.
2. Change the value of the playback setting. Your choices are:
•
YES
- The greeting will play on the headsets as well as the order point.
•
NO
- The greeting will only be heard at the order point (and the monitor if selected below).

Table of Contents

Other manuals for 3M XT-1

Related product manuals