3M XT-1 - Alert Message External Trigger Inputs

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 49 of 65
Appendix: Greeter Module
3. Using the 5 , 6 , 4 , 3 and Enter keys, select a message
number and configure the settings. Your choices are:
• Priority
• <Y> - means the message will enter a queue if the scheduled play time
occurs during an active order. The message will play when the current
vehicle departs or the call is dropped by the order taker.
• <N> - means the message will be skipped and not play if the
scheduled play time occurs during an active order.
• Delay
• <mm:ss> - Upon the start of a new day part, the playback of the first message will
be delayed by this setting, entered in minutes and seconds. If the delay places the
message start time into an active order, the message is skipped or placed into queue.
If the delay places the message outside an active daypart, the message is skipped.
• Count
• <XXX> - Count is the number of the times the message is scheduled
to be played during the current active daypart.
• Repeat
• <hh:mm:ss> - The repeat time, entered in hours:minutes:seconds, is the
amount of time elapsed before the next scheduled message plays, with
the elapsed time starting when the previous message finishes
• Monitor
• <OFF> - The selected message is not played to the grill monitor speaker.
• <ON > - The selected message is played to the grill monitor speaker, if one is installed.
Alert Message External Trigger Inputs
Perform the following procedure to select the function for each of four external inputs:
1. Enter the greeter configuration menu.
2. Select 7 Alert Message External Trigger Inputs .
:ALERT MESSAGE EXTERNAL TRIGGER INPUTS:
‘SPLIT/CROSS’ Input Pin= > Orignial Mode <
‘ORDER TAKING’ Input Pin= > Orignial Mode <
‘DAY/NIGHT’ Input Pin= > Orignial Mode < i