3M XT-1 - Detector Type; Kitchen Noise Reduction

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 18 of 65
Configuration
Perform the following procedure to enable or disable paging to be heard by operators on both lanes.
 • Enterthebasestationcongurationmode,seepage5.
 • Changethevaluefor
07 Global Settings > PAGE
Messages Can Cross Lanes? to YES or NO .
Detector Type
Because there are two basic types of vehicle detector, pulse and presence,
you must specify which type you have in the base station.
 • Enterthebasestationcongurationmode,seepage5.
 • Changethevaluefor 07 Global Settings > Vehicle Detector#1 to Presence or Pulse .
Note:
Vehicle detector#1 is always the order point.
 • Forpresencetypedetectors,specifyavaluefor Vehicle Detector #X Minimum
(Seconds) . Setting a higher number will increase the customerís wait time, but decrease
false detections that could be caused by cars driving over the detector without stopping.
Notes:
When the pulse setting is used, each call must be ended by pressing the page button on the
headset.
If you are using a vehicle detector board, the presence or pulse setting should match the dip
switch setting on the board.
If the vehicle detector is set to delay (via its own dip switches) and you set a delay in the base
station, the delays are additive: you could end up with a longer than expected total delay.
Kitchen Noise Reduction
Activating this option reduces the amount of background kitchen noise picked up by the
order takers headset microphone and transmitted to the order point speaker.
Perform the following procedure to enable or disable Kitchen Noise Reduction.
 • Enterthebasestationcongurationmode,seepage5.
 • Changethevaluefor 07 Global Settings > Kitchen
Noise Reduction to DYNAMIC or OFF.
Important Notes:
By default, the Kitchen Noise Reduction is set to DYNAMIC.
For this feature to function, all “signed-on” headsets must be of version 5.11 or later.
If even one headset of an older version signs on, the: feature will automatically be disabled
despite itís value remaining set as DYNAMIC base station emits 3 audible chirps and Run
Screen will display a message
“ Headset <XXXXXXX> allows kitchen noise ”.