3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 11 of 65
Configuration
Vehicle Approach
Some sites are equipped with a vehicle approach detector, which alerts you when a vehicle enters the parking
lot or drive through approach lane. If your site is equipped with the detector, you can change the volume
at which the tone is played on the monitor. Also, if you do not wish to hear the tone, you can disable it.
To change the vehicle approach monitoring settings:
• Enterthecongurationmode,seepage5.
• Select
02 Monitor Volume
.
• Toenableordisablethemonitorfromplayingthevehicleapproachtone,
change the value for
Vehicle Approach: Enable
to
ON
or
OFF
.
• Tochangethevolumelevel,selectanewvaluefor
Vehicle Approach:
Volume
. The range is 0 (silent) to 20 (maximum).
Page Messages
Paging is headset-to-headset communications. Changing the page message volume affects how loudly the
monitor plays internal paging messages. You can also disable the monitor playing internal paging messages.
Note:
To avoid feedback and echo, set the volume as low as possible.
To change the page message volume monitoring settings:
• Entertheuserservicemode,seepage5.
• Select
02 Monitor Volume
.
• Toenableordisablethemonitorplayinginternalpagingmessages,change
the value for
PAGE Messages: Enable
to
ON
or
OFF
.
• Tochangethevolumelevel,selectanewvaluefor
PAGE Messages:
Volume
. The range is 0 (silent) to 20 (maximum).
Greeter Messages
Changing the greeter message volume affects how loudly the monitor plays the greeter
messages. You can also disable the monitor playing the greeter messages.
To change the greeter message volume monitoring settings:
• Enterthecongurationmode,seepage5.
• Select
02 Monitor Volume.
• Toenableordisablethemonitorplayinggreetermessages,changethe
value for
Greeter Messages: Enable
to
ON
or
OFF
.
• Tochangethevolumelevel,selectanewvaluefor
Greeter Messages:
Volume
. The range is 0 (silent) to 20 (maximum).
To Next Page
Loading...
