3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 32 of 65
Operation
Split Lane
Split Lane mode is the preferred mode for heavy volume because it essentially
separates the communications between the two base stations.
• Operatorswillonlyhearasignalfromtheorderpointlastused:singlerepeating
beep from order point 1 or a double repeating beep from order point 2.
• TheheadsetbuttonsT1andT2communicateonlywithorderpoint1andorderpoint2,respectively.
• Forpaging,pressingthepagebuttononalane1headsetisonlyheardbyotherlane1headsets.
Likewise pressing the page button on a lane 2 headset is only heard by other lane 2 headset.
Notes:
A headset becomes a “lane 1” or “lane 2” headset by momentarily pressing and releasing the
T1 or T2 button.
You can configure the base stations to permit paging to be heard by both lanes. Refer to
configuration section of the manager’s guide.
Cross Lane
Cross Lane mode is the preferred mode for lighter volume or whenever one order taker
needs to answer both order points: essentially, the two order points cross over.
• Operatorswillhearsignalsfrombothorderpoints:singlerepeatingbeepfrom
order point 1 or a double repeating beep beep from order point 2.
• TheheadsetbuttonsT1andT2communicateonlywithorderpoint1andorderpoint2,respectively.
• Forpaging,pressingthepagebuttonisheardbyallheadsets.
Change Volume Mode
If you have night volume reduction in use on your system, the volume change happens
automatically at the set “Day” and “Night” times. However, you can change the
volume mode manually without changing the day or night time setting.
Perform the following procedure to change between night and day or day and night volume:
1. Press
6
until the
Volume
selection is highlighted.
2. Press Enter.
3. Use the arrows to select between
DAY
and
NIGHT
.
4. PressEnter to implement the change or press Mode to abandon
the change and leave the previous setting in effect.
To Next Page
Loading...
