3M XT-1 - Base Station Run Mode Operations

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 29 of 65
Operation
Base Station Setup
Most of the base station configuration is performed during installation by the installer
or by a manager. The setup options listed in this section are only those that can be
performed without entering the passcode-protected areas of the base station.
The following procedures are all performed at the base station using the base station keypad. The base
station must be turned on (plugged in) and in Run Mode without a security passcode entered.
The following diagram shows how the display on the base station looks in Run Mode.
Figure5
Navigating in the Base Station in Run Mode
To navigate the base station in Run mode you only need to use Enter, Mode, and
the directional arrow buttons: up 5 , down 6 , left 3 , and right 4 . The
remaining buttons function only in manager or installer configuration modes.
Change Order Taking Mode
There are seven order taking modes, which offer different combinations of speaking,
listening, automatic standby, vehicle detector, and order point modes.
Perform the following procedure to switch to a different order taker mode:
1. Press 6 until the Mode selection is highlighted.
2. Press Enter.
3. Press 5 , 6 , 3 or 4 to select a new order taker mode. Your choices are ML/
PTT , ML/MLT , AL/PTT , AL/MLT , Hands Free , Outside , and Always On . See
“Explanation of Order Taking Modes,” and “Which Order Taking Mode to Select” below.
Figure 5