3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 42 of 65
Appendix: Greeter Module
Appendix: Greeter Module
Greeter Setup
The Greeter Module is an accessory used to record messages and play them back, either
when a vehicle arrives (GREETER, CLOSED, FORWARD), when an event occurs, such
as a door opening (ALERT), or periodically on a schedule (REMINDER).
TheGreeterModulehasenoughmemorytostore64secondsofaudio,broken
intosixteen4secondmessages.Themessagetypesavailableare:
GREETER-EachGreetermessagetakesuptwo4secondmessageslotsforatotalof8
seconds. Greeter messages are restricted to ODD message numbers (i.e. 001, 003, 005,
007, 009, 011, 013, and 015). There can be a maximum of 8 Greeter messages.
REMINDER-EachRemindermessagetakesupone4secondmessageslotforatotalof4seconds.Reminder
messagescanberecordedinanyofthe16messageslots,allowingforamaximumof16Remindermessages.
ALERT-EachAlertmessagetakesupone4secondmessageslotforatotalof4seconds.Alertmessages
canberecordedinanyofthe16messageslots,allowingforamaximumof16Alertmessages.However,
thesystemhas4AlertMessageInputTriggers,soonly4Alertmessagescanbeusedatanyonetime.
CLOSED-The custom “Store Closed” message follows all the rules of a Greeter Message.
FORWARD- The custom Tandem Lane “Pull Forward” message follows all the rules of a Greeter Message.
Note:
For a Dual Lane system, some message types are not available. The message Types available on each
base station are as follows:
Lane 1 = GREETER, REMINDER, ALERT and CLOSED
Lane 2 = GREETER, CLOSED and FORWARD
Enter the Greeter Configuration Menu
All of the greeter module settings are located in the “Greeter Setup” configuration menu.
Perform the following procedure to enter the greeter configuration menu:
1. Enter the base station configuration mode, see page 5.
2. Press and release Mode until the
Greeter Setup
menu appears.
To Next Page
Loading...
