3M XT-1 - Set Valid Times; Time Definitions

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 59 of 65
Appendix: Timer Module
2. Select 3 Set Goal Times .
You can set goal times for every report period that is available in the
timer: full day reports, day part reports, and shift reports.
 • FULLDAYReports
  •7Daysoftheweek
 • DAYPARTReports
  • 8dayparts
 • SHIFTReports
  • 4shifts
For each of these time period selections, you can then set goals for the detector or report group available.
 • Anyof6DetectorInputs,or
 • Anyof6ReportGroups,or
 • TheGreetevent
Note:
Goal times are always set in mm:ss format
Set Valid Times
Perform the following procedure to change the Valid Times:
1. Enter the timer configuration menu, see above.
2. Select 3 Set Valid Times .
“Valid times” refers to the part of the day that the Timer System is active. Outside that
period, the XT-1 system ignores all vehicle detection signals and records no data.
ValidTimeisusuallysettomatchthestore’sworkingschedule,butitcanalso
be configured to allow monitoring of after hours drive-thru traffic.
Start and End Times for each day are set independently.
Ifastoreisopen24hoursaday,thenthevalidtimesStartandEndcanbesettothesamevalue.Any
value works except “00:00”. Start 00:00 and End 00:00 is reserved for a store that is closed all day.
So,toindicateastorethatisopen24hoursaday,wecoulduseStart00:01andEnd00:01.
Time Definitions
Perform the following procedure to change the Time Definitions:
1. Enter the timer configuration menu, see above.
2. Select 5 Time Denitions .