3M XT-1 - Change Site Information; Change Self Monitoring; Change Passcodes; User Passcodes

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 21 of 65
Configuration
Change Site Information
Site information is useful for warranty registration and to support service calls. This information
is most useful when the system has an internet connection. Tech Services can use it to identify
and contact the store when it receives a service request. All information is entered free-
format using the numeric keypad. To type upper case letters, use the Shift key.
Perform the following procedure to change the site information:
 • Enterthebasestationcongurationmode,seepage5.
 • Navigateto 11 Site Information .
 • Foreacheldthatneedstobemodied,entertheappropriatedata.
(Press 5 , 6 , 3 and 4 to scroll through the fields.)
Change Self Monitoring
Self-monitoring is a function available for all systems where the base station is continuously connected
to a store Ethernet connection. The base station keeps track of all of the headsets in the system,
looking for periods of extended non-use that may indicate a headset problem that needs attention.
Perform the following procedure to enable and configure self monitoring:
 • Enterthecongurationmode,seepage5.
 • Select 12 Self Monitoring .
 • Toenableordisableselfmonitoring,changethevaluefor
Self Monitoring Enabled? to Yes or No .
 • Ifselfmonitoringisenabled:
  • Selectavaluefor Number of Inactive Days Allowed . The range is 7 to 255. The
number represents how many days of inactivity must pass for any given headset before
the system interprets the absence as a problem and forwards the information to 3M.
  • Selectavaluefor Resend Error Reports . Your choices are Never , Every
Day , Every Week , or Every Month . This is the frequency that the base station
will attempt to resend the error message until the error condition is corrected.
Change Passcodes
User and installer passcodes can be individualized for better security control
against unauthorized changes. The system has a default user and a default installer
passcode pre-installed. Check your documentation for those passcodes.
User Passcodes
If you enter a user passcode, you have full access to the Change User
Passcodes menu. You can change or delete any passcode.