3M XT-1 - Headset Operation and Maintenance

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 25 of 65
Operation
Operation
Headsets
Overview
This chapter provides instructions for using headsets with an 3M™ Wireless Communication
System Model XT-1 after the system has been installed, configured, and powered on.
Component Identification and Description
Figure2
 • AdjustmentSlide: Push or pull to adjust for a comfortable fit.
 • IndicatorLED: Indicates operating status of the headset. See Indicator Light Modes below.
 • T1andT2 (Talk:buttons): Connect you to the order point.
1. When there are two order points, T1 connects to order point 1 and T2 connects to order point 2.
2. When there is only one order point, T1 and T2 both connect to the order point.
3. If you are in Manual Latching or Hands Free modes, the talk button establishes
youastheordertaker;andwhileyouaretheordertaker,thetalkbuttonisan
order point mute button (each tap turns mute on or off to the order point).
 • On/Off: Turns the headset on and off. Hold for 3 seconds to turn off.
 • Volume: The up button increases volume, the down button decreases volume.
 • Page: Has several functions related to in-store communication:
  4. Talktoallheadsetsonthesamelane(orbothlanesdependinguponthe
configuration), but not to the order point. Press and hold the page button during
normal operation to communicate with other headsets. There is an option in Global
settings to allow the order taker to hear or not to hear page messages.
T1
On/Off
T2
Volume up
Battery
Release
A
djustment
Slide
Indicator LED
Volume Down
Page