3M XT-1 - Order Taking Modes and Volume Control

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 30 of 65
Operation
Note:
Your system may be configured with fewer order taking mode options than the number
described in this section. You must enter User configuration (passcode required) to enable or
disable individual order taking modes.
Explanation of Order Taking Modes
The following table shows how each order taking mode affects components and settings in the
system. The paragraphs that follow the table explain the meaning of information in the table.
Order Taking
Mode
Listen Talk Vehicle
Detector
Automatic
Standby
Order Point
ML/PTT Manual Push to Talk Presence On Used
ML/MLT Manual Manual Latching Presence On Used
AL/PTT Automatic Push to Talk Presence On Used
AL/MLT Automatic Manual Latching Presence On Used
Hands Free Automatic Automatic Presence On Used
Outside Manual Manual Latching Ignored Off Not Used
Always On Always On Manual Latching Ignored Off Used
Listen:Auto,Manual,andAlwaysOn
In Manual Listen (ML), the operator must press the talk lane button to turn on the order point microphone
(to hear the customer order). The order point microphone will remain on until the vehicle leaves.
In Automatic Listen (AL), the order point microphone turns on and stays on whenever a
vehicle is detected. The order point microphone will remain on until the vehicle leaves.
In Always On, the order point speaker is always on so the customer can always be
heard regardless of whether a vehicle is detected at the order point. Always On is a
special failure mode that is useful if the vehicle detector cannot be used.
Talk:ManualLatching,PushtoTalk,Automatic
In Manual Latching Talk (MLT), the operator must press and release the talk lane button to
“latch” or lock the headset microphone in the on position. The operator can continue to speak
hands free until the talk button is pressed and released again. When Automatic Standby is on (see
below), the microphone will also be turned off when the vehicle is no longer detected.
In Push to Talk (PTT), the operator must press and hold the talk button while speaking
into the headset microphone. Releasing the button turns off the microphone.
In Hands Free, the headset microphone is on whenever the order point vehicle detector
detects a vehicle. Because Automatic Standby (see below) is also on when Hands Free
is On, the microphone is turned off when the vehicle is no longer detected.