3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 2 of 65
Overview
System Warnings
WARNING
To reduce the risks associated with hazardous voltage
• Disconnect power to the receptacle before installing or removing the Base Station
Power Supply. When removing receptacle cover screw, cover may fall across plug
pins or receptacle may become displaced. Use only with duplex receptacle having
centre screw. Secure unit in place by receptacle cover screw.
• If power supply is supplied with a grounding pin, connect directly to a grounding
receptacle - 3 prong.
To reduce the risks associated fire & property damage:
• Do not open, crush, expose to heat above 200 °F or incinerate the battery.
• Always replace batteries, battery chargers and power supplies with 3M approved
units acceptable for use in this system to avoid system function & safety concerns.
• Do not modify this 3M™ Wireless Communication System Model XT-1. Install only
3M provided components. Use only 3M approved system replacement parts.
CAUTION
To reduce the risk of associated with environmental contamination due to battery
pack and to lead in the solder:
• Dispose of batteries, power supplies, battery charger and base station in
accordance with federal, state & local requirements. If preferred, returned these
components to 3M service centre for disposal.
Other Conventions
Important Notes and Notes
Imporant Note:
It is strongly recommended that you pay attention to information inside of an
“Important Note:” box.
Note:
You may find information inside of a “Note:” box helpful.
To Next Page
Loading...
