3M XT-1 - System Setup and Defaults

3M™ Wireless Communication System Model XT-1
Store Manager Operating Instructions
November 2011 - Revision 1.8
Page 22 of 65
Configuration
Perform the following procedure to set up and/or change user passcodes:
 • Enterthecongurationmode,seepage5.
 • Select
13 Change Passcodes > Change User Passcodes .
 • Identifytheusernumberyouwanttochange,thenpress
5 , 6 , 3 and 4 as necessary to scroll to the desired passcode.
 • Enteranewfour-digitpasscodeinplaceoftheoldpasscode.
 • PressEnter to implement the change or press Mode to abandon the
change and leave the passcode at its previous setting.
Two Base Station Setup
In any installation where there are two base stations (tandem, side-by-side, or dual drive
thrus), register all headsets to Base Station #1. This ensures that changes to split and cross
lane mode and the order taking mode are synchronized between the two base stations.
The difference between split lane and cross lane modes in this situation is:
 • Splitlanemodeisintendedforadrivethruwithtwoordertakers.Eachordertakerhearsbeeps
only for the lane for which the headset is configured: beeps from the other lane will not be heard.
 • Crosslanemodeisintendedforadrivethruwithoneordertakerwhowillhearbeepsforbothlanes
on one headset. You can configure the system to permit non-order takers to hear orders and pages
from one or both sides. See “Order Takers and Page Messages in Cross Lane Mode,” page 17.
Installer Setup
Installer setup is a special group of setup options typically only used by the
installer or in case of complete system restoration or backup.
Load Installation Settings
Installation settings are a complete set of configuration data that the installer can save after
the initial installation configuration is completed. It is essentially a backup save point in case
configuration settings are inadvertently changed in ways that are not easy to identify or correct.
To load the installation settings:
Important Note:
By performing this procedure you will be erasing the current configuration and reloading the
configuration that was last saved, likely when the system was first installed.
 • Enterthecongurationmode,seepage5.
 • Select 14 Installer Setup .
 • Changethevaluefor Load Installation Settings to Yes .