124 | Aprisa LTE User Manual
DHCPv6 Client > Advanced Settings
This page configures the advanced settings of a DHCPv6 Client interface.
Use builtin IPv6-management
This parameter sets if IPv6 address ranges allocated to this interface will be delegated to other downstream
facing interfaces. Usually relevant to ports using DHCPv6 protocol, although can sometimes apply in other
unusual topologies.
Use default gateway
If this parameter is active, a default gateway discovered with RA protocol will be added to the routing table.
Use DNS servers advertised by peer
If this parameter is active, the DNS server advertised by the DHCPv6 server is used.
Override MTU
This parameter sets the MTU (Maximum Transmission Unit) largest possible size of a data packet between 0
and 1500. The default setting is 1500.
To Next Page
Loading...
