4RF Aprisa LTE - Page 87

Managing the LTE | 87
Aprisa LTE User Manual 2.1
LINK HEALTH CHECK SETTINGS
Health Check Test Type
This parameter sets the Health Check Test Type ping mode.
Option
Function
Disabled
Health Check Test is disabled
Continuous Ping
The ping test runs continuously
Timed Ping
The ping test runs for the duration specified in ‘Ping Test Duration’
parameter
Ping Counts
The ping test runs for the number of times specified in ‘Number of
Pings’ parameter
IP Address Type
This parameter sets the IP address type to IPv4 or IPv6.
Ping Destination IP Address
This parameter sets the destination IP address for the pings.
Inter-ping Interval (s)
This parameter sets the time in seconds between pings.
Ping Timeout (s)
This parameter sets the maximum amount of time in seconds to wait for a ping result.
Link Failure Ping Threshold (s)
This parameter sets the number of failed ping attempts to the destination address fails before an alarm is
raised. This alarm may also be used for switching to the secondary link.
Ping Test Duration (s)
This parameter sets the time in seconds that a single health check test runs for.
Number Of Pings (s)
This parameter sets the Number of Pings per health check test.