System Functions and Features as of I7.9
Routing elements 77
syd-0200/3.0 – I7.9 – 11.2009
Configuration:
Once a trunk group contains a B-channel group, the trunk group’s protocol can no
longer be changed. For this reason it is important to proceed using the following
configuration stages:
1. Enter the network interface of the basic or primary rate access in the first trunk
group (e.g. "3.17").
2. Set the trunk group protocol (e.g. DSS1).
3. Divide the B channels of the basic or primary rate access into B-channel groups.
The network interface already entered is changed to B channel group 1 (entry
changes to 3.17/1).
4. Enter the other B-channel groups in the required trunk groups. The protocol of
the first trunk group is set automatically.
Line group in the ISDN
Digital outside lines that are to have the same traffic characteristics can be grouped
into line groups in the public network (e.g. several basic accesses with the same
DDI block).
A line group must also be recreated in the PBX. For this the network connections of
the exchange lines of a line group must be allocated to the same trunk group (see
Fig. 30, page 77).
A line group can consist of basic accesses, primary rate accesses or individual B-
channel groups of primary rate accesses (also mixed).
Fig. 30 Recreating a line group in the PBX
-JOFHSPVQ
1#9
5SVOL
HSPVQ
5SVOL
HSPVQ
To Next Page
Loading...
