Test Procedure and Results 4-11
19. The analyzer checks the
rotor type, and begins
processing the sample
with no further input.
20. When the sample is finished processing, the analyzer stores the
results and shows that analysis is complete.
21. By default, the analyzer automatically prints the results of the analysis.
If the results do not print automatically, they can be recalled from memory and printed —
see “Searching Results” on page 6-3.
Note: Be sure to review the results printout for any suppressed results, which
are marked with these symbols: ~~~
22. Press OPEN to open the
rotor drawer.
23. Remove the rotor from the drawer.
Remove Rotor
CLOSE
To analyze additional sample,
load new rotor
To Next Page
Loading...
