Configuring the Analyzer 5-5
3. The analyzer displays the ranges for the species.
Select the analyte to adjust. If needed, use the up (S) and
down (T) arrow keys to scroll through the list.
4. Use the controls to set the upper and lower limits for the range.
■ Use the up (S) and down (T) arrow keys to adjust the
values.
■ Press Clear to set both limits to zero.
■ Press Default to use the factory default values for the
range.
5. Press Save to store the changes.
Adding a Species
Use this procedure to add reference ranges for a particular species (including pre-defined species).
1. In the Modify Reference Ranges screen, press Species.
2. Press Add Species.
Species 1 Ranges
HomeBack
ALB 3.3 - 5.5
g/dL
ALP
ALT
AMY
AST
3 - 5
3 - 6
2 - 4
1 - 3
U/L
U/L
U/L
U/L
ALB Default Range [g/dL]
SaveCancel
3.3 5.5
Lower
Upper
Clear Default
Species
HomeBack
Add Species
Remove Species
Factory Default Species
Dog
Cat
To Next Page
Loading...
