5-28 Configuring the Analyzer
Selecting Reports
Use this procedure to set the type and number of reports that can be printed automatically after a
sample is analyzed.
1. In the Printer Setup screen, press Configure.
2. Press Select Reports.
3. Select the report type.
4. Use the controls to adjust the number of copies to print.
■ Use the up (S) and down (T) arrow keys to adjust the
number.
■ Press Clear to set the number to zero.
■ Press Default to use the factory default value.
5. Press Save to store the new setting.
Configure Printer
Set Default
Select Reports
Back Home
Select Reports
Results: 1
iQC: 0
Errors: 1 Auto
Back Home
# Results Copies
2
Current
New
Clear
Default
1
HomeBack Save
To Next Page
Loading...
