ABB ACQ580 - Page 264

260 Parameters
76.33 Start point 4 Defines the start point for the fourth follower pump/auxiliary
motor. See parameter 76.30 Start point 1.
Vector:
1300 rpm;
Scalar 48 Hz;
58 Hz
(95.20 b0);
32.50; 17.50
76.34 Start point 5 Defines the start point for the fifth follower pump/auxiliary
motor. See parameter 76.30 Start point 1.
Vector:
1300 rpm;
Scalar 48 Hz;
58 Hz
(95.20 b0);
35.00; 15.00
76.35 Start point 6 Defines the start point for the sixth follower pump/auxiliary
motor. See parameter 76.30 Start point 1.
Vector:
1300 rpm;
Scalar 48 Hz;
58 Hz
(95.20 b0);
37.50; 12.50
76.36 Start point 7 Defines the start point for the seventh follower pump/auxiliary
motor. See parameter 76.30 Start point 1.
Vector:
1300 rpm;
Scalar 48 Hz;
58 Hz
(95.20 b0);
40.00; 10.00
76.37 Start point 8 Defines the start point for the eighth follower pump/auxiliary
motor. See parameter 76.30 Start point 1.
Note: This parameter is active only in the Level control only.
42.50; 7.50
76.41 Stop point 1 Defines the stop point for the first auxiliary motor. When the
speed of the motor connected directly to the drive falls below
this value and one auxiliary motor is running, the stop delay
defined by parameter 76.56 Stop delay is started. If the speed
is still at the same level or lower when the stop delay elapses,
the first auxiliary motor stops.
The running speed of the drive is increased by [Start point 1 -
Stop point 1] after the auxiliary motor stops
Vector:
800 rpm;
Scalar 25 Hz;
30 Hz
(95.20 b0);
15.00; 35.00
0.00…32767.00
[rpm/Hz] [m]
Speed/frequency 1 = 1 unit
76.42 Stop point 2 Defines the stop point for the second auxiliary motor. See
parameter 76.41 Stop point 1.
Vector:
800 rpm;
Scalar 25 Hz;
30 Hz
(95.20 b0);
15.00; 35.00
76.43 Stop point 3 Defines the stop point for the third auxiliary motor. See
parameter 76.41 Stop point 1.
Vector:
800 rpm;
Scalar 25 Hz;
30 Hz
(95.20 b0);
15.00; 35.00
76.44 Stop point 4 Defines the stop point for the fourth follower pump/auxiliary
motor. See parameter 76.41 Stop point 1.
Vector:
800 rpm;
Scalar 25 Hz;
30 Hz
(95.20 b0);
15.00; 35.00
No. Name/Value Description Def/FbEq16