ACS550 User’s Manual 37
Start-up, control with I/O and ID Run
After completing a set-up task, the Start-up Assistant suggests the
next one.
• Press (when
is highlighted) to continue with the
suggested task.
• Press key
to highlight and then press to move to
the following task without doing the suggested task.
• Press to stop the Start-up Assistant.
SAVING A USER PARAMETER SET AND FINAL CHECK
The start-up is now completed. However, it might be useful at this
stage to set the parameters required by your application and save
the settings as a user parameter set as instructed in section User
parameter sets on page 81.
After the whole set-up is completed, check there are no faults or
alarms shown on the display and the panel LED is green and does
not blink.
The drive is now ready for use.
OK
Continue
Skip
OK
EXIT
Do you want to
continue with
application setup?
Continue
Skip
EXIT
OK00:00
CHOICEREM
To Next Page
Loading...
