16 Start-up, control with I/O and ID run
In an edit view:
• Use and to move the cursor left and
right.
• Use and to change the value.
•Press (Save) to accept the new setting,
or press (Cancel) to go back to the
previous view without making changes.
To give the drive a name that will be shown at the
top, press .
If you do not want to change the default name
(ACS580), continue straight to the set-up of the
motor nominal values by pressing (Next).
Enter the name:
• To select the character mode (lower case /
upper case / numbers / special characters),
press until symbol is highlighted and
then select the mode with and . Now you
can start adding characters. The mode remains
selected until you select another one.
• To add a character, highlight it with and ,
and press .
• To remove a letter, press .
•Press (Save) to accept the new setting,
or press (Cancel) to go back to the
previous view without making changes.
ACS580 FW.book Page 16 Wednesday, September 21, 2016 9:48 PM
To Next Page
Loading...
