Start-up, control with I/O and ID run 17
Refer to the motor nameplate for the following nominal value settings of the motor. Enter the
values exactly
as shown on the motor nameplate.
Example of a nameplate of an induction (asynchronous) motor:
Select the motor type.
Check that the motor data is correct. Values are
predefined on the basis of the drive size but you
should verify that they correspond to the motor.
Start with the motor nominal current.
If you have to change the value, go to the edit
view of the selected row by pressing (when
this symbol is shown at the end of the row).
Set the correct value:
• Use and to move the cursor left and
right.
• Use and to change the value.
Press (Save) to accept the new setting, or
press (Cancel) to go back to the previous
view without making changes.
Continue to check/edit the nominal values and
select scalar or vector control mode.
Motor nominal cos Φ and nominal torque are
optional.
Roll down with
to see the last row in the view.
After editing the last row, the panel goes to the
next view.
To go directly to the next view, press (Next).
M2AA 200 MLA 4
1475
1475
1470
1470
1475
1770
32.5
56
34
59
54
59
0.83
0.83
0.83
0.83
0.83
0.83
3GAA 202 001 - ADA
180
IEC 34-1
6210/C36312/C3
Cat. no
35
30
30
30
30
30
50
50
50
50
50
60
690 Y
400 D
660 Y
380 D
415 D
440 D
V
Hz kW
r/min A
cos
IA/IN
t
E/s
Ins.cl. F
IP 55
No
IEC 200 M/L 55
3
motor
ABB Motors
ACS580 FW.book Page 17 Wednesday, September 21, 2016 9:48 PM
To Next Page
Loading...
