22 Start-up, control with I/O and ID run
2 – Additional settings: Limits
Select Limits and press (Select) (or ).
Adjust the parameters according to your needs.
Select a parameter and press
(Select).
After making the adjustments, go back to the
Primary settings menu by pressing
(Back).
3 – I/O menu
After the additional adjustments, make sure that
the actual I/O wiring matches the I/O use in the
control program.
In the Main menu, select a I/O and press
(Select) to enter the I/O menu.
Select a the connection you want to check and
press
(Select) (or ).
ACS580 FW.book Page 22 Wednesday, September 21, 2016 9:48 PM
To Next Page
Loading...
