ABB ACS800-17LC - Switching the Control Panel between the Supply and Inverter Units

Start-up
114
Switching the control panel between the supply and inverter units
The control panel is switched between the supply unit and inverter units as follows:
WARNING! The drive does not stop by pressing the control panel Stop key in remote
control mode.
Changing control to the supply unit
Step Action Press… Display (example)
1. To enter the Drive Selection Mode
Note: In local control mode, the inverter unit trips if
parameter 30.02 PANEL LOSS is set to FAULT. Refer to
the appropriate application program firmware manual.
2. To scroll to ID number 2
3. To verify the change to the supply unit and display the
warning or fault text
Changing control to the inverter unit
Step Action Press… Display (example)
1. To enter the Drive Section Mode
2. To scroll to ID number 1
3. To verify the change to the inverter unit
DRIVE
ACS 800 0490_3LM
ASXR7xxx
ID-NUMBER 1
ISU 800 0490_3LM
IXXR7xxx
ID-NUMBER 2
ACT
ISU 800 0490_3LM
DC OVERVOLT (3210)
2 -> 380.0 V
*** FAULT ***
DRIVE
ISU 800 0490_3LM
IXXR7xxx
ID-NUMBER 2
ACS 800 0490_3LM
ASXR7xxx
ID-NUMBER 1
ACT
FREQ 0.00 Hz
CURRENT 0.00 A
POWER 0.00 %
1 L -> 0.0 rpm I