Technical data
162
Efficiency
> 97% (at rated current and nominal supply voltage)
Degree of protection
IP42 (UL Type 1), IP54, (UL Type 12)
Ambient conditions
Environmental limits for the drive are given below. The drive must be used in a heated,
indoor controlled environment.
Operation
installed for stationary use
Storage
in the protective package
Transportation
in the protective package
Installation site altitude 0 to 4000 m (13123 ft) above
sea level. 690 V units: 0 to
2000 m (6562 ft) above sea
level. Above 1000 m (3281
ft), see Derating on page
146.
--
Air temperature 0…+55° (+32…+131°F), no
frost allowed
[above +45°C (+113°F), see
Derating on page 146]
-40…+70°C (-40 to +158°F) -40…+70°C (-40 to +158°F)
Relative humidity 5 to 95% Max. 95% Max. 95%
No condensation allowed. Maximum allowed relative humidity is 60% in the presence of
corrosive gases.
Contamination levels
(IEC60721-3-3, IEC60721-3-2,
IEC60721-3-1)
No conductive dust allowed.
Boards with coating:
Chemical gases: Class 3C2
Solid particles: Class 3S2
Boards with coating:
Chemical gases: Class 1C2
Solid particles: Class 1S3
Boards with coating:
Chemical gases: Class 2C2
Solid particles: Class 2S2
Atmospheric pressure 70 to 106 kPa
0.7 to 1.05 atmospheres
70 to 106 kPa
0.7 to 1.05 atmospheres
60 to 106 kPa
0.6 to 1.05 atmospheres
Vibration Marine requirements
±1 mm (peak value,
2…13.2 Hz)
0.7g (13.2 - 100 Hz)
Max. amplification 10
IEC 60068-2-6
0,075 mm (0…58 Hz)
10 m/s
2
(58…150Hz)
Max. amplification 10
1M2, IEC 60721-3-1
1.5 mm (2…9 Hz)
5 m/s
2
(9…200 Hz)
2M2, IEC 60721-3-2
3,5 mm (2…9 Hz)
10 m/s
2
(9…200 Hz)
Random 10-200 Hz,
acceleration spectral density
1 m2/s³
Shock (IEC 60068-2-29) Not allowed Max. 100 m/s
2
(330 ft./s
2
),
11 ms
Max. 100 m/s
2
(330 ft./s
2
),
11 ms
Free fall Not allowed 100 mm (4 in.) for weight
over 100 kg (220 lb.)
100 mm (4 in.) for weight
over 100 kg (220 lb.)
Materials
Cabinet Hot-dip zinc-coated (thickness approx. 20 µm) steel sheet (thickness 1.5 mm) with
polyester thermosetting powder coating (thickness approx. 80 µm) on visible surfaces
except back panel. Colour: RAL 7035 (light beige, semigloss).
Busbars Tin- or silver-plated copper
To Next Page
Loading...
