Mechanical installation
57
Moving the unit by fork-lift or pallet truck
Moving the unit on rollers (not allowed with marine cabinets)
Laying the unit on its back
It is not allowed to transport or lay the unit on its back.
The centre of gravity is high. Be therefore careful when
transporting the unit. Avoid tilting the cabinets.
The units are to be moved only in the upright position.
If using a pallet truck, check its load capacity before
attempting to move the unit.
Remove the wooden bottom frame which is part
of the shipment.
Lay the unit on the rollers and move it carefully
until close to its final location.
Remove the rollers by lifting the unit with a
crane, fork-lift, pallet truck or jack as described
above.
To Next Page
Loading...
