Mechanical installation
62
Fastening the unit to the floor and wall (marine units, option +C121)
1. Bolt the cabinet to the floor through the holes in each flat bar at the base of the
cabinet using M10 or M12 screws. Note: Welding is not recommended, see
page 67.
2. If there is not enough room behind the cabinet for installation, clamp the rear
ends of the flat bars.
3. Remove the lifting bars and fasten the top of the cabinet to the rear wall and/or
roof using brackets.
1
2
3
Cabinet roof
M16 bolt
L-bracket
Back panel of cabinet
Flat bars at base of cabinet
Clamps (not
included in
delivery)
To Next Page
Loading...
