Maintenance
133
Installing the installation stand
An installation stand for supply and inverter module replacement is available from
ABB as an accessory. The order code is 68847711.
1. Fasten the module installation stand to the frame of the cubicle (2 × 5 screws).
Align the stand and the rails in the cubicle on which the module lies. Adjust the
height of the feet. Note: Remove the cabinet hinge first if necessary.
WARNING! The feet must lean on a solid floor. The cubicle may topple over when
the heavy module is pulled out if the stand is not supported properly.
Do not overtighten (max.
torque 5.5 N·m [4 lbf·ft]).
Ensure that the guide studs
are in frame holes before
tightening screws.
Fixing of triangular support
Brace
Fixing of braces
Slide plane and support feet
Hooks at this end of plate have
to enter holes in frame cabinet.
With these threads it is possible to fix
the unit to the slide plate.
Do not use more than one
slide plate at a time.
These hooks must enter
holes in the brace.
To Next Page
Loading...
