ABB ACS800-17LC - Connection to a cooling unit; General requirements; Coolant temperature control; Installation

Maintenance
132
Installing the winch
The winch is available from ABB as an accessory. The order code is 68847826.
1. Fasten the right-hand side support of the winch to the support frame of the
cubicle (four screws). Fasten the left-hand side support of the winch to the
support frame of the cubicle (four screws). Note: Position the guide pins of the
supports in the holes of the cabinet frame before tightening the screws.
2. Lead the beam (a) through the left and right winch support and the winch body.
Lock the beam with two locking pins (b).
WARNING! Before fastening the lifting bar to the module, always ensure that the
lifting cable is tightly wound on the drum of the winch. A slack cable may slip, making
the lifting of a heavy module unstable. A swinging or falling module may cause
damage, injury or even death. See page 18 for detailed information on safe use of
the winch.
2
b
1
a
b
Do not overtighten!
Max.torque 5.5 N·m
(4 lbf·ft). Ensure that
the studs are inserted
into frame holes when
tightening the screws.