Introduction to the manual
22
Technical data contains the technical specifications of the drive eg, ratings, frame
sizes and technical requirements and provisions for fulfilling the requirements for CE
and other markings.
Dimensions contains information on the dimensions of the drive.
Related documents
See the List of related manuals on the inside of the front cover.
Categorization by frame size and option code
The instructions, technical data and dimensional drawings which concern only
certain drive frame sizes are marked with the symbol of the frame size (such as
“2×R8i+2×R8i”, etc.). The frame size is not marked on the drive designation label. To
identify the frame size of your drive, see section Type equivalence table on page
147.
The instructions and technical data which concern only certain optional selections
are marked with option codes eg, +E202.
The options included in the drive can be identified from the option codes visible on
the type designation label. The option selections are listed in section Type
designation key on page 50.
Quick installation and start-up flowchart
Task See
Plan the installation.
Check the ambient conditions, ratings, required
external cooling arrangements, input power
connection, compatibility of the motor, motor
connection, and other technical data.
Select the cables.
Technical data, page 145
Planning the electrical installation, page 69
Option manuals (if optional equipment is
included)
Unpack and check the units.
Check the type code indicated by the type
designation label with the original order. If the drive is
about to be connected to an IT (ungrounded) system,
check that the drive is not equipped with EMC filtering
+E202. Check that all necessary optional modules
and equipment are present and correct.
Mechanical installation, page 55
Hardware description, page 27
For instructions on how to disconnect the EMC
filtering, contact your local ABB representative.
If the drive has been non-operational for more
than one year, the drive DC link capacitors
need to be reformed. Contact your local ABB
representative for more information.
Only intact units may be started up.
Check the installation site. Checking the installation site, page 55
To Next Page
Loading...
