Hardware description
51
Resistor braking D150 Brake choppers of type NBRW (for 690 V units only)
D151 Brake resistors in a separate IP21 cubicle. Available with +D150 only. Not available
with +C129.
D152 3-phase brake choppers. Control panel CDP312R included on the cubicle door.
Filters E202 EMC filter for first environment TN (grounded) system, category C2. Not available for
units with rated current I
cont.max
above 1000 A.
E205 du/dt filter for frame R7i
E206 Sine output filter. Air-cooled, IP21. Not available for +C121, +C129 or +C134.
E214 RFI filter for marine applications.
Line options F271 Knobs for grounding the AC output busbars temporarily. Available with +H359 only.
F259 Grounding switch. Not available with options +C129 and +C134 or frames R7i+R7i
and R8i+R8i.
F269 Output contactor. Available for ACS800-17LC-0870-3, -1030-5 and -1240-7 and larger
units.
Heaters and auxiliary
control voltage
G300 Cabinet heater (external supply)
G304 115 V AC control voltage
G307 Terminals for connecting external control voltage (230 V AC or 115 V AC
uninterruptible power supply)
G313 Output for motor heater (external supply)
Materials G330 Halogen-free wiring and materials. Not available with +C129 and +C134.
Push buttons G331 Emergency stop push button (red) and reset button (blue lighted) on the cabinet door
Meters G335 A-meter in one phase
3G335 A-meter in three phases
G334 V-meter with selector switch
Wire markings G338 Equipment pin numbers are printed on wires between modules and on wires
connected to equipment.
G339 Equipment and terminal block pin numbers are printed on wires between modules and
on wires connected to equipment and terminal blocks. Main circuit conductors are
marked.
G340 Equipment pin numbers are marked with rings on wires between modules and on
wires connected to equipment, terminal blocks and detachable screw terminals. Main
circuit conductors are marked.
G341 Equipment identifications and terminal block pin numbers are marked by rings on
optical fibers, on wires between modules, and on wires connected to equipment,
terminal blocks and detachable screw terminals. Main circuit conductors and also
short and obvious connections are marked.
G342 Equipment identifications and terminal block pin numbers and remote addresses are
marked by rings on optical fibers, on wires between modules, and on wires connected
to equipment, terminal blocks and detachable screw terminals. Main circuit
conductors and also short and obvious connections are marked.
Cabling H351 Top entry of cables
H353 Top exit of cables
H358 Cable gland plates (steel 3 mm, undrilled)
H359 Motor cable terminal cubicle
H364 Cable gland plates (aluminium 3 mm, undrilled)
H365 Cable gland plates (brass 6 mm, undrilled)
Class Code Description
To Next Page
Loading...
