ABB CRB 1300 - Page 451

NoteAction
xx2000001678
Make sure that :
• the block on the mechanical stop flange is
towards the upper side (process hub side).
• the notches on the tubular and the mechan-
ical stop flange are aligned.
2
xx2000001718
Refitting the axis-4 mechanical stop slider
NoteAction
xx2000001732
Place the axis-4 mechanical stop slider in the
housing.
1
Refitting the housing
NoteAction
O-ring on tubular: 3HAC061327-
018
For robots with protection class IP67 (option
3350-670)
1
xx2000002519
Valid for CRB 1300-11/0.9 and CRB 1300-10/1.15
Check the O-ring.
Replace if damaged.
Continues on next page
Product manual - CRB 1300 451
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued