404 Parameters
200.73 SMS limit positive Sets the positive speed limit for the SMS
function.
Note: This parameter is used only in version
2 of the SMS function.
0.0 rpm
0.0…35880.0 rpm Speed
200.101 SAR0 version Shows the version of the SAR0 function. Version 1
Version 1 Version 1.
200.102 SAR0 ramp time to
zero
Sets the target time for the SAR0 ramp
(used in the SSE function).
Target time = Time in which the drive
decelerates the motor from speed 200.202
SAR speed scaling to zero.
1ms
1…1,800,000 ms Time
200.111 SAR1 version Shows the version of the SAR1 function. Version 1
Version 1 Version 1.
200.112 SAR1 ramp time to
zero
Sets the target time for the SAR1 ramp
(used in the SS1 and SLS functions).
Target time = Time in which the drive
decelerates the motor from speed 200.202
SAR speed scaling to zero.
Note: With value 0 ms, the drive (parameter
23.23 Emergency stop time) defines the safe
stop ramp. The FSO module monitors the
actual ramp using SAR1 parameters (ramp
monitoring) or parameter SS1.14 SS1-t
delay for STO (time monitoring).
1ms
0…1,800,000 ms Time.
200.201 Drive general
settings version
Shows the version of the drive general
safety settings (includes parameters
200.202, 200.222, 200.223 and 200.254).
Version 1
Version 1 Version 1.
200.202 SAR speed scaling Sets a speed value that the FSO module
uses as a reference point in ramp time
calculations.
See section Ramp monitoring on page 57.
1500 rpm
0…35880 rpm Speed
200.222 Safety bus type Sets the type of the safety fieldbus (if used).
Note: To activate the safety fieldbus, you
must also set parameter SBUSGEN. 01
SBUS activity and version to value Version
1.
Not used
Not used The safety fieldbus is not used.
PROFIsafe PROFIsafe
Index Name/Value Description Factory
default
To Next Page
Loading...
