ABB FSPS-21 - Page 205

DescriptionData typeR/W
1)
Par. no.
Load parameter recordUnsigned16R/W970
DescriptionValue
No action0
Restore factory settings1
The parameter must do a zero-to-one transition and the
motor must be stopped.
Save parameter recordUnsigned16R/W971
DescriptionValue
No action0
Save the drive parameters to non-volatile
memory
1
The parameter must do a zero-to-one transition and the
motor must be stopped.
Software resetUnsigned16R/W972
DescriptionValue
No action0
Re-boot PROFIBUS module1
The parameter must do a zero-to-one transition and the
motor must be stopped.
DO identification. For subindexes 0…4, see parameter 964.
Array[n] Unsigned16R975
MeaningSub-index
Value 2 = Axis5
Number list of defined parameters. If the subindex is 0, the
end of the list has been reached. If the subindex is the num-
ber of the next list parameter, the list is continued there.
Array[n] Unsigned16R980
981
Map 16-bit selection
3)
. Used to request the data type for
mapped parameters if mapping is done with parameter 915
or 916.
Unsigned16R/W1000
DescriptionValue
User 16-bit mapping, if available.1
Disable alarms.Unsigned16R/W50000
DescriptionValue
PNIO alarms enabled0
PNIO alarms disabled1
Name of stationVisibleString24R61000
IP of stationUnsigned32R61001
MAC address of stationOctetString[6]R61002
Default gateway of stationUnsigned32R61003
Appendix A – PROFIdrive parameters and I&M records of PROFINET IO 205