ABB Relion 670 series - Exporting SCL Files from PCM600; Exporting SCD Files

SCD file
 do IED engineering
 export SCD file
PCM600
 create project
 import SCD file
 configure data sets
 configure Report CBs
 configure GOOSE CBs
 export SCD file
IET600
 import SCD file
 link GOOSE input data
 Write to IED
PCM600
SCD file
IED 1 IED nIED 2 IED n-1
IEC11000264-2-en.vsdx
2
3
1
IEC11000264 V2 EN-US
Figure 69: IEC 61850: Signal engineering procedure flow
8.3 Exporting SCL files from PCM600
GUID-2A07D447-0EC8-45BC-9C71-1A015F030C3F v6
The pre-condition for exporting SCL files from PCM600 is that IEDs included in
the project are configured. The hardware interface, for example the IP address,
must be selected and configured. Station communication has to be activated in the
IED, that is, the IEC 61850-8-1 setting Operation must be set to On.
8.3.1 Exporting SCD files
GUID-2FDA859B-3761-4310-BEFF-11BB046A406B v2
Procedure for exporting SCD files from PCM600:
1. Select the sub-station in the plant structure (see
Figure 70).
Section 8 1MRK 511 398-UEN C
IEC 61850 communication engineering
112 670 series 2.2 IEC
Engineering manual