10.4 Setting DNP3 signal parameters
GUID-F762121A-41E5-49F1-9359-205CF9E15304 v1
Two parameters per signal can be set for all signal types:
• The index of the signal
• The class configuration
Procedure to set the index of the signal:
1. Click the two inner arrows to sort signals to another index sequence, or select
Set Index ... from the context menu to move one or a set of signals to another
array, see Figure 99.
IEC08000336 V2 EN-US
Figure 99: CMT: Context menu in DNP3 window
2. The selection window shows the number of signals selected, see Figure 100.
IEC08000363 V2 EN-US
Figure 100: CMT: Set Index menu
3. Define the Starting index for this group and click OK.
Procedure to set class configuration:
1. Click in the class field of the signal to change the class configuration.
2. The Select Class window opens.
3. Make the selection according to the definitions in the project and click OK to
close the window and get the new configuration, see Figure 101.
Section 10 1MRK 511 398-UEN C
DNP3 communication engineering
142 670 series 2.2 IEC
Engineering manual
To Next Page
Loading...
