IEC11000424 V2 EN-US
Figure 92: Communication Management tool
3. Select the signals and move them into the DNP signal list of the master. DNP
point zero and one of the Binary Input Objects are used for indicating the
active setting group in this case.
IEC11000425 V2 EN-US
Figure 93: Selecting the signals into the DNP signal list
10.3 Configuring DNP3 protocol signals
GUID-4908ED38-733F-4A8B-AEB2-90C0CB9A5274 v4
1. Save the actual project configuration in PCM600 to make all signals visible for
CMT.
1MRK 511 398-UEN C Section 10
DNP3 communication engineering
670 series 2.2 IEC 139
Engineering manual
To Next Page
Loading...
