IEC10000172 V1 EN-US
Figure 94: Configuring hardware channels directly to the function blocks
IEC10000173 V1 EN-US
Figure 95: CMT: Hardware channels appearing in the Communication
Management Tool
2. Right-click the IED in the plant structure and select Communication
Management to start the Communication management tool.
3. Select the DNP3 protocol from the new window and click OK.
Figure 96
presents the design of the two container windows, which open after the
selection of DNP3.
• The right window shows tabs for possible communication channels.
• The left window has a drop down menu for signal selection and buttons
for signal movement, see Figure 96.
Section 10 1MRK 511 398-UEN C
DNP3 communication engineering
140 670 series 2.2 IEC
Engineering manual
To Next Page
Loading...
