ABB Relion 670 series - Starting the Ethernet Configuration Tool

This tab allows configuration of the routing of data packets. Each row in this tab
corresponds to a Route. Changing settings in this tab will not have any impact on
the SCL model.
Table 5: Routes tab
Column
Description Read only
Route Route instance. Yes
Name Name of the route. No
Operation Enable/disable the route operation. No
Gateway IP adress Gateway IP address of the route.
For routing, Gateway IP address should be
within the subnetwork of the access point.
No
Destination IP
address
Destination IP address of the route. No
Destination subnet
mask
Destination subnetwork mask of the route. No
5.2 Starting the Ethernet configuration tool
GUID-3DB1C6C8-09C6-4460-A903-AA722888AFD9 v1
The tool can be started the from the IED level in the Plant Structure window in
PCM600.
1. Right click on the IED.
2. Select Ethernet configuration from the menu.
1MRK 511 398-UEN C Section 5
Ethernet configuration tool
670 series 2.2 IEC 65
Engineering manual