11.4.1.1 IED mapping in PCM600 Plant Structure
GUID-AD017D10-E128-44E0-A758-E3CD95FA5975 v2
IED mapping
IED mapping is done in plant structure by dragging and dropping a PCM600 IED
from the Unassigned IEDs group on an FPN IED in the Substation. IED mapping
status is indicated visually in the plant structure.
Removing the IED mapping
IED mapping is removed from the plant structure by dragging and dropping a
mapped FPN IED onto the Unassigned IEDs group. The removed mapping will be
indicated visually in the plant structure. The PCM600 internal IED, with which the
unmapped FPN IED was mapped, will appear back in the Unassigned IEDs group
if it is not anymore mapped with any FPN IEDs.
11.4.1.2 IED mapping in the IEC 61850 Structure Mapping Tool
GUID-07F9D393-FE3C-4392-8943-202D7ECB1587 v2
IED mapping
The tool will display all FPN IEDs and all PCM600 IEDs in separate lists.
Mapping will be done by dragging and dropping the PCM600 IED on the right
hand side to FPN IED on the left hand side. The tool indicates the mapping status
visually.
Click save button of the IEC 61850 structure mapping tool to apply the mapping.
IEC15000090 V2 EN-US
Figure 107: Mapping of IEDs in IEC 61850 structure mapping tool
IEC15000091 V2 EN-US
Figure 108: Visual indication of the mapping
1MRK 511 398-UEN C Section 11
Flexible product naming
670 series 2.2 IEC 149
Engineering manual
To Next Page
Loading...
