ABB RET615 User Manual

LD0.MAPGAPC17 Multipurpose protection (17).................... 51
LD0.MAPGAPC18 Multipurpose protection (18).................... 51
LD0.RESTCTR1 Io CT supervision (1).................................. 51
LD0.RESTCTR2 Io CT supervision (2).................................. 52
LD0.RESTVTR1 Uo VT supervision (1)................................. 52
LD0.SPCGAPC1 Generic control point (16 pcs) (1)...............52
LD0.TRPPTRC3 Master trip (3)............................................. 53
LD0.TRPPTRC4 Master trip (4)............................................. 53
LD0.TRPPTRC5 Master trip (5)............................................. 54
LD0.UL1TVTR1 Three-phase VT supervision (1).................. 54
Registers.......................................................................................... 54
Premapped registers................................................................... 55
Active parameter setting group - read and write.................... 55
Control structure 1..................................................................55
Control structure 2..................................................................55
Control structure 3..................................................................55
Control structure 4..................................................................56
Control structure 5..................................................................56
Control structure 6..................................................................56
Control structure 7..................................................................56
Control structure 8..................................................................57
Device ID string...................................................................... 57
Event record structure............................................................ 57
Fault record structure header................................................. 61
Fault record data.................................................................... 61
Protection relay's real-time clock (in local time mode) -
read and write (synchronize).................................................. 65
Protection relay's real-time clock (in UTC time mode) -
read and write (synchronize).................................................. 65
Indication bits mirrored in registers........................................ 66
SSR1 System status register (1) device health......................66
SSR2 System status register (2) protection relay's mode
and state.................................................................................67
SSR3 System status register (3) data available 1 (client-
dependent)............................................................................. 67
SSR4 System status register (4) data available 2 (client-
dependent, user-definable).................................................... 68
SSR5 System status register (5) device alive register........... 68
SSR6 System status register (6) control command status
(client-dependent).................................................................. 69
System diagnostic values.......................................................69
Time and reason for latest protection relay reset................... 70
User-definable bits [Alt.2], visible on 0x,1x,3x and 4x............ 70
User-definable registers [Alt.1], visible on 3x and 4x............. 71
Table of contents
4 RET615
Point List Manual

ABB RET615 Specifications

General

Rated Frequency	50/60 Hz
Weight	Approx. 2.5 kg
Type	Protection Relay
Communication Protocols	IEC 61850, Modbus, DNP3
Protection Functions	Overcurrent, Earth fault, Thermal overload, Frequency
Input Voltage	24-250 V DC