- 17 -
T005CH2
Transportation and handling
Transportation of the equipment, especially by road, must be carried out by suitable ways and means for protecting
the components (in particular, the electronic components) from violent shocks, humidity, vibration, etc. During
handling, do not make any sudden or fast movements that can create dangerous swinging.
NOTE: During transportation the crated TRIO inverters should only be stacked three high.
For storage purposes, units in their original unopened packaging can be stacked ve high on a at
dry surface capable of withstanding the weight.
DO NOT stack with equipment or products other than those indicated or store in damaging, corrosive
environments.
Lifting
ABB packages and protects individual components using suitable means to make their transport
and subsequent handling easier. Due to the weight and complexity of this equipment, ABB
recommends the process of loading and unloading of this equipment be done by an experienced
or specialized staff knowledgeable in material handling.
Where indicated or where there is a provision, eyebolts or handles can be inserted and used as
lifting points. Do not lift several units or parts of the equipment at the same time, unless otherwise
indicated.
Incoming inspection
It is the customer’s responsibility to examine the condition of the unit. Upon receipt of the inverter,
please check the following:
• Inspect the shipping container for any external damage.
• Inventory the contents against the table below and verify receipt of all items.
• Use care not to discard any equipment, parts, or manuals.
• Call the delivering carrier if damage or shortage is detected.
2
Installation location
To Next Page
Loading...
