45 UK
12.6 Outputs
Here you can separately specify the type and polarity for each output 1 to 4.
The device has four programmable outputs (OP1 to OP4).
OP1 = output 1
OP2 = output 2
OP3 = output 3
OP4 = output 4
With these outputs, a number of different functions can be implemented, for
example:
Triggering of signaling devices
Switching of lighting, fans, etc.
The outputs can also be controlled remotely.
Output types
OFF:
The output is permanently disabled (default).
Message Waiting:
The output is activated when a message is waiting and
deactivated when the message has been played once.
Remote Access:
The output is activated upon remote access via
telephone. The output is reset when the remote dial-in is
finished.
High Temperature:
The output is activated when the preset temperature
threshold is exceeded. The output is deactivated when
the temperature falls below the defined threshold again.
See setting in “System Settings Alarm Levels High
Temperature”
Low Temperature:
The output is activated when the preset temperature
threshold is undershot. The output is deactivated when
the temperature rises above the defined threshold again.
See setting in “System Settings Alarm Levels Low
Temperature”
Listen Active:
This output is activated when listen mode is started.
See also “Operation Remote Access Functions in
Remote Access Mode”
Speech Active:
This output is activated when speech mode is activated.
To Next Page
Loading...
Need help?
General
