38 UK
With the UCP protocol, this number is transmitted as part of the SMS
message.
This number is not transferred with the TAP protocol.
12.3.4 Display Options
Flash On Message
When enabled (ON), the backlight of the display flashes
when a reminder message (memo) is waiting (default).
Playing the reminder message stops the flashing.
When the function is deactivated (OFF), the backlight does
not flash.
Beep On Message
When the function is activated (ON), the device beeps
every minute when a reminder message (memo) is waiting.
Playing the reminder message stops the beeping.
When the function is deactivated (OFF), the device does
not beep (default).
Temperature Display
When the function is activated (ON), the display shows the
current ambient temperature in degrees Celsius (default).
No temperature is displayed when this function is
deactivated (OFF).
Phone Line Fault
Any telephone line faults are stored in the event memory.
Display Off
When this option is selected, the telephone line fault is
only stored in the event log (default).
Display On
When this option is selected, the device indicates every
telephone line fault on the display with “Phone Line
Fault”. No warning signal sounds.
Display and Beep
When this option is selected, the device indicates every
telephone line fault on the display with “Phone Line
Fault”, and the device beeps every minute. To mute the
tone if the fault persists, open the programming menu.
Note:
It can take up to 60 seconds before the fault is
displayed.
To Next Page
Loading...
Need help?
General
