6146/6156 DC Voltage/Current Generators Operation Manual
2.3.1 Memory Recall Mode
2-43
4. Press the TRIG HOLD once to increase the memory number by one. The source
value of the next memory number is displayed.
Every time the source value is recalled, blinks once.
In this way, every time TRIG HOLD is pressed, the memory number is
increased by one.
Using , or also increases or decreases the memory number by one.
The memory number can be directly input using DATA.
5. Pressing STOP (PRGM MODE) resets the memory number to 0.
Setting the first number and the last number
The first number and the last number are set using the FIRST (DOWN) and LAST
(UP) keys.
1. Press PRGM MODE once on the HOME screen to set the memory recall mode.
2. Press FIRST (DOWN) to set the first number setting display.
3. Move the cursor with , , and change the figure with , or .
4. Press LAST (UP) to set the last number setting display.
5. Move the cursor with , , and change the figure with , or .
6. Press LAST (UP) or EXIT to exit the last number setting display and return to
the memory recall mode screen.
Cursor (blinking)
Cursor (blinking)
Cursor (blinking)
To Next Page
Loading...
Need help?
General
