6146/6156 DC Voltage/Current Generators Operation Manual
2.3.1 Memory Recall Mode
2-45
6. Pressing TRIG HOLD while the scan is running pauses the scan.
7. Pressing TRIG HOLD again while the scan is paused resumes the scan from the
number at which it was paused.
8. Pressing STOP (PRGM MODE) while the scan is running or paused stops the
scan, returning to the first number.
2.3.1.2.3 Executing Repeat Scan
1. Press PRGM MODE once on the HOME screen to set the memory recall mode.
If the program mode is switched in Operate status, the output status will become
Standby.
Example using the 6156
2. Press SCAN MODE several times to set the repeat scan mode.
When the repeat scan mode is set, "rEPEAt" is displayed for about a second.
The source value of the first number is recalled.
3. Press OPR to set the output status to Operate.
4. Press TRIG HOLD to start repeat scan.
The memory data from the first number to the last number is recalled repeatedly
at intervals specified by the step time.
Blinking
Cursor (blinking)
Blinking
To Next Page
Loading...
Need help?
General
