2.11
MAINTENANCE
ENGINE
Transmission Oil Level
Maintain the oil level within the safe range on the filler plug.
Do not overfill.
To check the oil level:
1. Position the vehicle on a level surface.
2. Remove the filler plug.
3. Check oil lever by glass widow.
NOTE: Rising oil level between checks in cool
weather driving, can indicate moisture collecting in
the oil reservoir. If the oil level is over the full mark,
change the oil.
4. Add the recommended oil as needed.
NOTE: Do not fill the over the normal oil operating
range. Filling over the normal operating range could
cause a mist of oil to enter the air box.
5. Reinstall the filler plug.
Transmission Oil Change
1. Position the vehicle on a level surface.
2. Clean area around the drain plug.
3. Run engine two to three minutes until warm.
4. Stop the engine.
5. Place a drain pan beneath the mission case.
6. Remove the drain plug. Allow the oil to drain completely.
7. Inspect the O-ring on drain plug, replace if needed.
NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks
or scratches.
11. Remove the dipstick. Add 30 oz. (900 ml) of recommended oil. Do not overfill.
12. Reinstall the filler plug.
13. Start the engine. Allow it to idle for one to two minutes.
To Next Page
Loading...
Need help?
General
